LDAP ==== There are two ways to do LDAP authentication: * [AuthDatabase.LDAP.PasswordLookups.txt] * [AuthDatabase.LDAP.AuthBinds.txt] Both of these have their own advantages and disadvantages. * [AuthDatabase.LDAP.Userdb.txt] Configuration common to LDAP passdb and userdb ---------------------------------------------- Connecting ---------- There are two alternative ways to specify what LDAP server(s) to connect to: * 'hosts': A space separated list of LDAP hosts to connect to. You can also use host:port syntax to use different ports. * 'uris': A space separated list of LDAP URIs to connect to. This isn't supported by all LDAP libraries. The URIs are in syntax 'protocol://host:port'. For example 'ldap://localhost' or 'ldaps://secure.domain.org' If multiple LDAP servers are specified, it's decided by the LDAP library how the server connections are handled. Typically the first working server is used, and it's never disconnected from. So there is no load balancing or automatic reconnecting to the "primary" server. SSL/TLS ------- You can enable TLS in two alternative ways: * Connect to ldaps port (636) by using "ldaps" protocol, e.g. 'uris = ldaps://secure.domain.org' * Connect to ldap port (389) and use STARTTLS command. Use 'tls=yes' to enable this. See the tls_* settings in 'dovecot-ldap-example.conf' for how to configure TLS. (I think they apply to ldaps too?) SASL binds ---------- It's possible to use SASL binds instead of the regular plaintext binds if your LDAP library supports them. See the sasl_* settings in 'dovecot-ldap-example.conf'. Note that SASL binds are currently incompatible with authentication binds. Active Directory ---------------- When connecting to AD, you may need to use port 3268. Then again, not all LDAP fields are available in port 3268. Use whatever works. (This file was created from the wiki on 2011-08-29 04:42)