Completing Your Configuration

If you have storage devices that do not fully support serialization and this is the first time you have run the wizard, or you did not make any configuration changes when you ran the wizard previously, you will see the following results on this wizard screen:

• Any drives that are not configured for a robot appear under the Standalone Drives node.
• The robot node will have empty nodes under it for each available drive address in the robot.

  To complete a configuration

1. If you have a robot that is not configured correctly and you know the correct drive numbers in the robot, drag the drives to the empty drive node having the corresponding robot drive number. Refer to your vendor documentation for the robot for help in determining the drive numbers.
2. If you want the robot and drives enabled, select the check boxes for the robot and drives.

   The following point applies only to NetBackup Enterprise Server.

   You cannot enable or disable shared drives from this wizard screen.